diy
 






 

Question by  silverfox52 (16)

What is involved in refinishing an antique rocker?

 
+7

Answer by  Liz59 (10966)

Well, to refinish the rocker you have to get some glazing. Preferably go to a hardware store like Home Depot and you can choose what kind of glazing you need based on the color and the coating. The glazing gives it that great finish that the furniture will need in the long run.

 
+6

Answer by  Jane42 (201)

Determine whether the rocker needs refinishing by cleaning with oil soap. Apply refinisher to the chair and use steel wool to remove the old finish. Wipe with clean rags. Work slowly and carefully.When all of the old finish has been removed, apply polyurethane varnish. Allow to dry completely between coats.

 
+6

Answer by  ca1111 (95)

First you need to clean the rocker with clean rags and Murphy's oil soap. Then apply refinisher with steel wool in small areas at a time. Apply polyurethane once the old finish is removed and the refinisher has evaporated completely.

 
+6

Answer by  heatherh (33)

Remove the old paint or finish with a medium grit sandpaper. With a foam brush apply the new finish. Watch for drips. Let dry for atleast 24 hours.

 
+5

Answer by  mrsmyers (474)

It is not a very difficult process to refinish an antique rocker. You just need to sand it down and seal it.

 
+5

Answer by  gpchicky1 (7)

The chair must be stripped with a heavy-body furniture stripper using 0 grade steelwool,sanded with 100 grit paper, and then repaired,if needed. Stain is then applied by rag or brush,let dry, and then 2 coats of a clear lacquer or urethane finish, sanding between coats with 200 grit paper. Final sanding with 400 grit paper.

 
+5

Answer by  ktow70 (305)

there is not to much to it but hard labor first need to sand the entire chair will need diffrent sanding tool becuse of grooves and notches this is the hard but most people do not sand enough after that it is as simple as finding a stain and appling do not over apply

 
You have 50 words left!